← Setup

Dashboard Settings

Configure substation names, gauge scale ranges, display units, and per-substation overrides.

Substation Names

These 3 substations appear as the main groups on the dashboard. Meters are assigned to one of these in their Edit Meter page.

Substation 1

Substation 2

Substation 3

Eskom Supply Regions (SLD)

Names the two Eskom supply sources and picks which region feeds each substation, for the Single Line Diagram.

Region 1 name

Region 2 name

Shakaskraal Substation → region

Stanger Substation → region

Driefontein Substation's → region

Gauge Scale Ranges

The global min/max for each gauge type shown on the dashboard. Per-substation overrides below can replace these for individual substations.

Current Min (A)

Current Max (A)

Power Min (MW)

Power Max (MW)

Voltage Min (kV)

Voltage Max (kV)

PF Min

PF Max

Gauge Display Size

Gauge Width (px)

Gauge Height (px)

Sub-card Min Width (px)

Thresholds & Limits (NRS / NERSA)

Green / amber / red bands for the dashboard gauges and the substation outlier tints. A reading inside the Green band shows green; inside the Amber band shows amber; outside both shows red. Defaults follow NRS 048-2.

Metric	Green Min	Green Max	Amber Min	Amber Max
Voltage (kV)
Power Factor
Frequency (Hz)
Voltage THD (%)
Current THD (%)
Current TDD (%)

Current Limits

Current is set per context (Amps differ by feeder/CT). Substations left blank inherit Total. Per-meter uses each meter's CT primary (set in Edit Meter) × the % below.

Context	Green ≤	Amber ≤
Total (all substations)	A	A
Shakaskraal Substation	A	A
Stanger Substation	A	A
Driefontein Substation's	A	A
Per meter (% of CT primary)	%	%

Status Colours

Colours for value text, gauge arcs and tile tints across the dashboard. Value text is normally near-black and turns amber as a reading nears its limit, red when out of limit.